Hi Everyone,
Occasionally, in our pottery at Llanover Hall, you might see a highly polished /burnished pot that has no glaze on it whatsoever, yet it looks almost like glass. To create this burnished effect, you apply a mixture of terra sigillata. Now it might sound like some fancy Italian salad dressing, but it is, in fact, a mixture of water, dry clay and sodium silicate. You then rub it onto the surface of your pot and it will remove any coarse particles from the clay powder. It enables burnishing and a glossy surface, without the use of a glaze.
So, what is terra sigillata? The term means ‘sealed earth.’ The Romans and particular the Greeks used the technique to create their famous black and red pottery.
You can’t buy terra sigillata, so if you want to have a go, you’ll have to make your own.
To make terra sigillata you mix clay with water and a deflocculant, which is a thinning agent. You will need a clear glass or plastic jar with a wide mouth, and accurate scales, also a length of clear plastic tubing for syphoning.
To summarise, the ingredients are water, dry clay and deflocculant. The most common deflocculant is sodium silicate, but there are many others you could try. Most clays are suitable to produce the mix. Many kinds and colours of clay can be used, including ball clay, kaolin, local clay or scraps of whatever clay body you usually work with.
It is a question of experimenting with different types of clay until you find something suitable. Below is a guideline and there are many more online. The process is simple, but a bit time-consuming.
First, measure your water, and stir in the deflocculant. Weigh out your clay and add it to the water. For best results, be sure to weigh these materials precisely. Shake or stir your mixture vigorously. Then place the jar, loosely covered, somewhere, where it won’t be disturbed for several hours to several days.
After the appropriate settling period, you will see a layer of dark sludge on the bottom of your jar, and if it has been a long settling period you may see clear or dark-coloured water on the top, this varies depending on the type of clay and length of settling. It is the part in the middle – hopefully, about half the mixture – which you need. Use a syringe to carefully remove as much of the water from the top as you can without taking any of the fine clay particles along.
When clay starts getting into your syringe, it’s time to siphon off the middle layer into a clean container, using the clear plastic tubing – or for a small batch, simply use the syringe. Don’t be greedy. If you get some of the heavy sludge into your terra sig, it may never settle back out and you’ll have gritty terra sigillata, which won’t shine up as well. It’s a good idea, when you get close to the layer of sludge, to switch to a new container, so if some of the sludge gets in you don’t contaminate the whole batch. You now have a batch of rather thin terra sigillata (along with a lot of sludge, which can be discarded or used for some other purpose).
Terra sigillata can be applied in two ways, by brushing or spraying. Brushing is easier, but may leave noticeable brush-marks. On the other hand, spraying requires more equipment, and may leave a bit of a pebbly texture, where the droplets land on the pot.
The work is then fired, to make it waterproof, the inside of the pot can be glazed after the first firing, but do not glaze the outside, as it will destroy the effect, the terra sigillata has created.
Have a go, look online for some more details and recipes, and let me know how you get on.
Until next time,
Barry